Great Plains TS1000 Trailer Sprayer Operator Manual - Manual (Page 24)

Great Plains Mfg., Inc.
TS1000
22 7/6/09 TS1000 Trailer Sprayer 500-111M
Tank Fill Using Existing Pump Operations
The Tank Fill can be used to fill the main sprayer tank us-
ing the existing sprayer pump. To do so refer to the follow-
ing instructions:
1. Make sure sprayer pump is off and insert supply tank
hose into the walk-board quick-fill coupler. Leave
quick-fill valve off.
Refer to Figure 16
2. Turn agitation valve #1 to “OFF”. Turn tank valve #2 to
“MAIN TANK”. Turn operation valve #3 to “QUICK FILL
W/ PUMP”.
3. Open supply tank valve making sure that positive
head pressure is maintained at the quick-fill to prevent
back-flow from the sprayer tank.
!
WARNING!
Make sure the supply tank is higher than the sprayer tank. Fail-
ure to do so can cause back-flow from the sprayer tank causing
sickness, serious injury or death from water contamination.
4. Open quick-fill valve under the walk-board.
Refer to Figure 17
5. Turn product valve #4 from “OFF” to “TANK FILL”.
6. Make sure the boom section valve switches are all off,
start the pump and fill the tank.
7. When finished, follow this order:
a. Turn off pump.
b. Rotate product valve #4 from “TANK” to “OFF”.
c. Shut quick fill valve under walkboard.
d. Shut off supply tank valve.
e. Rotate operation valve #3 to “SPRAY”.
NOTE: Make sure there is positive head pressure from
supply tank during this procedure.
Figure 16
Control Panel
Figure 17
Product Valve and Inductor Valve
14993
22674