Great Plains DVN8324 Assembly Manual - Manual (Page 20)

16 8315-8324DVN Great Plains Manufacturing, Inc.
550-466Q-ENG 11/25/2013
Install K-Flex
Note: See machine layouts in “Operator’s Manual” for
proper shank placement.
Refer to Figure 10
57. Slide k-flex shank mount
through slot in k-flex
clamp . Slide these two parts over frame tube in
proper location.
58. Align top hole in k-flex clip with top hole in k-flex
clamp , secure with 1/2 x 1 1/2 hex bolt , 1/2 lock
washer and 1/2 nut. Install 1/2 x 5 hex bolts , 1/2
lock washers and 1/2 nuts.
59. Slide shank through slotted hole in k-flex clamp ,
secure with 5/8 x 2 hex bolt and 5/8 top lock nut.
Attach sweep with 7/16 x 1 3/4 plow bolts , one,
7/16 flat washer and 7/16 nylock nuts.
60. Tighten all bolts to specs, See “Torque Values
Chart” on page 37.
Install Magnum Shank
Note: See machine layouts in “Operator’s Manual” for
proper shank placement.
Refer to Figure 11
61. Position pre-assembled shank mount assembly
over front of frame tube in proper location. Secure
with 5/8 x 4 1/32 x 4 3/4 u-bolt
and 5/8 top lock
nut.
62. Be sure the 3/4 nylock jam nut is loose enough for
shank cradle to pivot.
63. Loosen 1/2 x 1 1/2 hex bolt clear up to get 5/8 x 2
hex bolt installed.
64. Slide shank into shank cradle until holes are
aligned, secure with 5/8 x 2 hex bolt and 5/8 top
lock nut.
65. Align sweep with holes on shank , secure with 7/
16 x 1 3/4 plow bolts , one, 7/16 flat washer and
7/16 nylock nuts.
66. Re-tighten 1/2 x 1 1/2 hex bolt until threads bot-
tom out. Be sure and tighten 3/4 nylock jam nut
until threads bottom out to insure that hole doesn’t
wear excessively.
67. Tighten rest of bolts to specs, See “Torque Values
Chart” on page 37.
Figure 10
K-Flex Assembly
41667
8
9
6
2
7
5
3
4
1
10
1
2
3
2 4
5
6 1
7
8 9
10
Figure 11
Magnum Shank Assembly
41668
6
1
5
3 9
7
2
8
4
1
2
3
4
6
5
6
7 5
8 9
4
3