Great Plains DVN8324 Assembly Manual - Manual (Page 21)

Great Plains Manufacturing, Inc. Assembly 17
11/25/2013 550-466Q-ENG
Refer to Figure 12
Install Gang Hangers
Note: See layout section in “Operator’s Manual” for proper
gang hanger placement.
68. Install gang hanger to proper frame tube with 5/8 x
3 1/32 x 5 1/2 u-bolts , 5/8 lock washers and 5/8
nuts.
69. Slide cupped washer and spring over gang
spring bolt .Slide gang spring bolt through gang
hanger tube, secure with 1 flat washer , 1 hex nut
and 1 jam nut .
70. Install gang lift cylinders , as shown, with 1 x 3 1/8
pins , 1.5 x 1.0 x.075 machine washer and 3/16 x 2
cotter pin.
Refer to Figure 13
71. Tighten 1 hex nut
to preload of 8 3/4 (22.23cm)
72. Tighten down 1 jam nut See “Refer to Figure 12”
on page 17.
73. Tighten rest of bolts to specs and bend cotter pins.
Figure 12
Gang Assembly
41551
8
9
6
2
7
5
3
4
1
10
1
1
2
4 5
3 3
1 6
7 8
9
10
Figure 13
Gang Hanger Spring Adjustment
41575
7
8