Parking, Storage, Parking storage – Great Plains 3N-4025P Operator Manual User Manual
Page 41
Great Plains Manufacturing, Inc.
Operating Instructions
37
2014-01-29
196-538M
Parking
Following these steps when parking the drill for periods
of less than 36 hours. For longer periods, see Storage,
the next topic.
1.
Spot the drill on firm, level ground.
2.
Raise the drill. Install transport locks.
3.
Fold as necessary for the parking space available.
4.
Securely block drill tires to prevent rolling.
Roll-Away Hazard
Always block drill tires when unhitching. There is not enough
weight on tongue to anchor drill using parking jack.
Do NOT unhitch on a steep slope.
Always unhook safety chain LAST.
Storage
Store the drill where children do not play. If possible,
store inside for longer life, or cover with tarp.
5.
Unload seed boxes.
6.
Lubricate the drill at all points listed under
“Lubrication” on page 154.
7.
Check all bolts, pins, fittings and hoses. Tighten,
repair or replace parts as needed.
8.
Check all moving parts for wear or damage. Make
notes of any parts needing repair before the next
season.
9.
Plug or cap seed delivery tubes to prevent pest entry.
10. Grease exposed cylinder rods to prevent rust. Be
sure to completely de-grease before next use, to
prevent seal damage.
11. Use touch-up paint to cover scratches, chips and
worn areas to prevent rust.
Figure 37
Drill on Parking Stand
20273