ADS Environmental Services Eureka2R QR 775019 A1 - Manual (Page 25)

ADS Eureka2R Leak Noise Correlator User Manual
21
Vehicle-mounted antennas may be used to increase the range of the system. To
connect this kind of an antenna, remove the fitted antenna located above the
connecting elbow (i.e., unscrew the black sleeve).
Turning On the Unit
Turn on the unit by momentarily pressing the button at the top right-hand
side of the keyboard. Press the button again to turn off the unit.
Note: Do not repeatedly press the ON button; Eureka2R performs a
boot sequence similar to a computer. It takes 3 to 4 seconds for the red
ON light to appear and an additional 6 to 7 seconds for the display to
illuminate.
When the Eureka2R screen appears, press any key to advance to the main
menu.
To conserve the battery charge, the correlator automatically turns off if no key
has been pressed after 15 minutes. A warning beep will sound for the last 2
minutes of this timing cycle.
Resetting the Correlator
In the unlikely event the correlator locks up, reset it by holding down the ON
button until the screen clears. This may take up to 20 seconds.
The correlator is then ready for use and may be turned on again in the usual
manner.