ADS Environmental Services Eureka2R QR 775019 A1 - Manual (Page 29)

ADS Eureka2R Leak Noise Correlator User Manual
25
Pipe Details
The Pipe Details button allows you to select the pipe material, diameter, and
length; you may select up to six different pipes for a survey length.
Enter the length of the selected section using the alphanumeric keys, and then
press the Enter button.
Select the pipe material from a list. Change the selection from material to
material or scroll through the combinations of material and diameter. Be sure
to select the correct diameter range and material. Press the Enter key (
↵) to
confirm the selection.
If the pipe length contains sections of different materials or diameters, the
arrow keys allow you to include or subtract a later section of pipe at the Red or
Blue ends. You may define up to six separate sections. The pipe length
displays with the sections shown proportionally. All sections display as the
same length until all lengths have been entered. An arrow connects a data box
to a section of pipe. The left and right arrow keys move the arrow from one
section to another. Enter the material and length for each section, as described
above.
The correlator preserves the pipe details until it is turned off. The default pipe
details are restored once the unit is turned on again. However, the default
values can be modified through the Eureka2R PC software.
To restore the default pipe values, select Mode > Survey.
Pipe details
Mode
This function allows the correlator to be used for various tasks.