Amico Mira LED - Manual (Page 20)

20 Amico Lighting Solutions
WARNING
Danger of death from electric shock.
• Before installation disconnect plug from mains
and set switch to off position.
• Check the connecting cable for damage at least
once a year.
NOTICE
• All maintenance and repairs must be done by an
electrician.
• Fort he corresponding user profile see Safety
Instructions section in this manual.
Setting Spring Force
NOTICE
The spring force is set to an optimum setting at the
factory.
• Remove the bend cover sideways.
Setting spring force 1:
• + Increase (when spring arm lowers)
• - Reduce (when spring arm is too high) until the
required stability is reached.
• Install the bend cover sideways.
Disassembly
WARNING
Danger of death from electric shock.
• Before installation disconnect plug from mains
and set switch to off position.
WARNING
• Never unscrew the top cable retainer.
• If both cable retainers are unscrewed, the
connection will be loose and will fall, which may
cause injury and damage to the cables and lamp.
Disposal
• Do not dispose of the light with the normal
refuse. Dispose oft he light at a recycling centre
or return it to a dealer with a disposal service
depending on local regulations. Cut off the cable
flush with the housing.
Maintenance
ENG MAINTENANCE; Setting spring force
18
NOTICE
The local government regulations for
disinfection must also be observed in addition to
these instructions.
NOTICE
Sterilise handle at 120°C and 1.05 bar for
30 minutes.
11 MAINTENANCE
WARNING
Danger of death from electric shock.
 Before installation disconnect plug from
mains and set switch to off position.
 Check the connecting cable for damage at
least once a year.
NOTICE
 All maintenance and repairs must be done
by an electrician.
 Fort he corresponding user profile see
Sec.3 Safety Instructions.
11.1 Setting spring force
NOTICE
The spring force is set to an optimum setting at
the factory.
 Remove the bend cover sideways.
Setting spring force 1:
 + increase (when spring arm lowers)
 - reduce (when spring arm is too high) until
the required stability is reached.
 Install the bend cover sideways.
ENG MAINTENANCE; Setting spring force
18
NOTICE
The local government regulations for
disinfection must also be observed in addition to
these instructions.
NOTICE
Sterilise handle at 120°C and 1.05 bar for
30 minutes.
11 MAINTENANCE
WARNING
Danger of death from electric shock.
 Before installation disconnect plug from
mains and set switch to off position.
 Check the connecting cable for damage at
least once a year.
NOTICE
 All maintenance and repairs must be done
by an electrician.
 Fort he corresponding user profile see
Sec.3 Safety Instructions.
11.1 Setting spring force
NOTICE
The spring force is set to an optimum setting at
the factory.
 Remove the bend cover sideways.
Setting spring force 1:
 + increase (when spring arm lowers)
 - reduce (when spring arm is too high) until
the required stability is reached.
 Install the bend cover sideways.