Apricorn Aegis Bio 3.0 - Solid State Drive - Manual (Page 12)

12
Enrolling a new finger
If there are less than 5 fingerprints enrolled and you want to enroll a new
finger, follow the instructions below.
1.
Plug in the Aegis Bio to a USB port on your computer. The LED
should be Solid
RED indicating that the drive is Standby mode.
2. Push the ENROLL button for 3 seconds.
If less than 5 fingerprints are enrolled, the
BLUE LED will become Solid
BLUE and RED LED will remain illuminated. Proceed to Step 3.
If 5 fingerprints are enrolled, the
BLUE and GREEN LED will come on for
2 seconds and the RED LED will be Solid RED . You will not be able to
enroll any more fingerprints.
3.
Swipe a finger that has been previously enrolled. The
GREEN LED
will flash if the fingerprint is accepted. If the fingerprint is not accepted the
RED
LED will flash.
4.
Once the fingerprint is accepted the
BLUE LED will become Solid BLUE
and the GREEN
LED will continue flashing, indicating that the Aegis Bio is
ready to enroll a new fingerprint.
5. Swipe a new finger. The
BLUE LED will turn off while the GREEN LED
starts to flicker briefly as the Aegis Bio processes your new fingerprint.
Wait until the BLUE LED turns back to Solid BLUE and the GREEN LED
returns to its flashing state.
6.
Repeat Step 5 until both the
BLUE and GREEN LED are in a solid state,
indicating that your fingerprint is fully enrolled.
NOTE: Once enrolled, fingerprints cannot be un-enrolled individually.
To remove enrolled fingerprints, a complete re-set of the drive is
required.