Apricorn Aegis Bio 3.0 - Solid State Drive - Manual (Page 8)

8
Getting Started - Out of the Box
1. Attach the integrated USB cable of
the Aegis Bio to an available USB
port on your computer. The Aegis
Bio LEDs will show Solid
BLUE and
Flashing GREEN indicating that the
drive is ready to enroll your fingerprint.
2. Swipe your Finger. The BLUE LED
will turn off while the GREEN LED
starts to flicker briefly as the Aegis Bio
processes your fingerprint.
Wait until the BLUE LED turns back
to Solid BLUE and the GREEN LED
returns to its flashing state.
3. Continue to repeat Step 2 until both
the
BLUE and GREEN LED are
in a solid state, indicating that your
fingerprint is fully enrolled.
NOTE: The number of attempts will vary depending on the quality of
the fingerprint read. For most people six swipes will be sufficient.
If there is a problem with a fingerprint read, the
BLUE LED will turn off and
the RED
LED with start to flash.
4.
To enroll more fingerprints, press the ENROLL button within 15
seconds from your last successful fingerprint enrollment and repeat
the process in steps 2 and 3.
NOTE: A maximum of 5 fingerprints can be stored. There is a 15 second
timeout between entering fingerprints. If the ENROLL button is not pressed
again after the last fingerprint, the unit will assume no more fingerprints will
be entered and return to a standby state.
Once 5 fingerprints have been stored, all three LEDs will turn on. After 2
seconds the
GREEN and BLUE LED will turn off with just the Solid RED
LED showing. At this point no more fingerprints can be enrolled.
NOTE: Once enrolled, fingerprints cannot be un-enrolled
individually. To remove enrolled fingerprints, a complete re-set
of the drive is required.
TIP: We highly recommend that you enroll at least three
different fingers to ensure access to the drive in the case
that your primary finger cannot be used.