B&G H2000 Pilot *DISCONTINUED* - Manual (Page 20)

Tank Level Sensing Processor and Sensors
Page 16
8.3 Calibration Procedure
To start the PC utility:
ú
Ensure that the Tank Monitoring Processor is connected to one of the PC’s COM ports
(COM port numbers over 8 are not recognised by the software)
ú
Ensure that the B&G system power is switched on.
ú Start the B&G Tank Monitoring System PC Utility on the PC.
ú The software will identify the COM port and establish communication with the Tank
Monitoring System. [If the software is unable to detect the Tank Monitoring System the
software will ask that you check the connections and power to the system].
Once the software has started and communications are established, the software will display the
current settings from your processor. If this is the initial calibration then the data displayed will
be the factory defaults.
8.3.1 To configure a tank :
•
Select the desired tank using the “Select a Tank” drop down box. The screen is
updated with the current configuration of the tank selected:
An example of a typical Tank Configuration screen shot