Baseline Systems BaseStation 6000 - Manual (Page 4)

4
8. Click Return to save your changes and go back to the Base Unit tab.
7. In the Communication Setup dialog box, select the Communication Type for the RBU.
 If a serial to wired backbone Bridge Unit is part of the system configuration, be sure to select the check
box in the Communication Setup dialog box for each RBU that you are setting up.
 If Network is the Communication Type for the selected RBU, select that option, and then type the serial
port number and the IP address for your network.
 If Mesh Radio is the Communication Type for the selected RBU, select that option, and then type the
MAC address that is listed on the Mesh Radio Module of the RBU.
Mac Address found on the
Mesh Radio Module sticker
Baseline Inc.
Phone: 866.294.5847 · Fax: 208.323.1834 · www.baselinesystems.com
 If Radio to Radio to Bridge is the Communication Type for the selected RBU, select the Mesh Radio
option, and then type the MAC address that is listed on the Mesh Radio Module of the RBU. Also select
the Bridge Unit/Remote Base check box at the bottom of the Communication Setup dialog box.