Baseline Systems BaseStation 6000 - Manual (Page 6)

6
Step Two: Enter the Baseline biCoder Addresses for the Zones
1. Click the Config Zone tab on the Main Page of the BaseStation 6000 software.
2. Find the serial number of each biCoder. The number of the two-wire biCoder is printed on a sticker that is
attached to the side of each biCoder. The serial number of the powered biCoder is located on the inside of the
enclosure door.
6. Click OK. Additional programming fields display.
7. Type a description for the zone so you can easily identify it.
8. Assign a program number to the zone in the Prog# field.
3. Make sure you know what zone each biCoder is attached to.
4. Starting with the biCoder for zone 1, double-click in the box in line 1 under the Serial Number column for
Address line 1.
5. Type the serial number for the zone 1 biCoder, and then press Enter. The Configuration Status message
displays.
9. Repeat Steps 1 through 8 for all biCoders and zones that are attached to the specific RBU that you are
configuring.
Note: Program numbers
must be unique on each
Remote Base Unit (RBU).
For example, if RBU 1 has
programs numbered 1, 2,
and 3, then RBU 2 will have
programs numbered 4, 5,
and 6.
Baseline Inc.
Phone: 866.294.5847 · Fax: 208.323.1834 · www.baselinesystems.com
Note: The package contains two
extra label stickers that you can
attach to your site plans for
future reference.