Canon VB-C500D - Manual (Page 57)

Initial Setting and
Insta
llatio
n
of Camer
a
2-15
Step 4 Install the Camera
Note on Use before Installing the Camera
Be sure to install the camera after setting the IP address (  P. 2-10).
Note
The camera will stop issuing IP address assignment requests in 20 minutes after its power
is turned on, upon which detection by VB Initial Setting Tool will be disabled. Before
installing the camera, set the IP address and check the operation by referring to "Perform
Initial Setting of the Camera" (
 P. 2-10).
The unique MAC address of this camera is specified at the bottom of the camera (
 P. 1-21).
It is recommended to write down the MAC address before installing the camera.
Note
For installation or inspection of the VB-C500D, consult/request the store where
you purchased the product.
• Wire the VB-C500D power supply, network, or other cables safely and securely
according to the relevant regulations such as technical standards for electrical
installations.
• Before the installation, select an installation location (ceiling, etc.) having
sufficient strength to withstand the weight of both the camera and any options
to be used (optional Recessed Mounting Kit). If necessary, provide sufficient
reinforcement and use the bundled safety wire.
• To prevent injuries and equipment damage due to falling items, periodically
check the brackets and screws for rusting and loosening.
• Installing the camera in locations subject to strong vibration is not
recommended. Equipment damage may occur.
• Do not install the VB-C500D on an unstable or inclined surface.
• Do not carry the product while the LAN cable or other cables are still
connected to it.
Malfunction may occur.