BlueAnt X3 Micro Bluetooth Headset - Manual (Page 12)

Using your headset with multiple Bluetooth devices
Note:
Your headset takes time to set up the Bluetooth connection with the required phone. If
you hear the ring tone from your headset, short press MFB again to answer this call.
3. End the call by short pressing the MFB .
To make a call using voice dialing
Make sure your phone supports voice dialing and your phone and headset is both powered on
within range of each other, and voice commands have been recorded into the phone.
1. Voice dialing through the current connected device by short pressing the MFB once on
your headset.
21
22
2. After you hear a beep, say the name of the contact you want to call.
3. To cancel the voice dialing or end the call, short press the MFB .
Note: To voice dial from another phone if you are already connected to a phone, short press
MFB
and VOL to disconnect. Then short press the MFB One ,Two or Three times
depending on the phone required.
To redial the last call
1. Make sure your phone support Handsfree profile.
2. Redial the last call through the current connected device by long pressing the
Volume down button on your headset.
Note:
Last call redial works when using the current connected phone and also and using the first
paired phone when not connected. It may take a while to set up the Bluetooth
connection if the Bluetooth connection is down.
3. To cancel the last call redial or end the call by short pressing the MFB .