Cooper Instruments & Systems TT03C Digital Cap Torque Gage - Manual (Page 7)

Series TT03 Digital Torque Gauges User’s Guide
6
8 High / low limit
indicators Correspond to the programmed set points. Indicator definitions are as follows:
– the displayed value is greater than the upper load limit
– the displayed value is between the load limits
– the displayed value is less than the lower load limit
9 Set points The programmed load limit values. Typically used for pass/fail type testing.
One, two, or no indicators may be present, depending on the configuration
shown in the Set Points menu item.
4.2 Controls
Primary
Label Primary Function
Secondary
Label Secondary Function
Powers the gauge on and off. Press
briefly to power on, press and hold
to power off. Active only when the
home screen is displayed. ENTER Various uses, as described in the
following sections.
ZERO Zeroes the primary reading and
peaks.
(UP)
Navigates up through the menu and
sub-menus .
MENU Enters the main menu. ESCAPE Reverts one step backwards through
the menu hierarchy.
MODE Toggles between measurement
modes.
(DOWN)
Navigates down through the menu
and sub-menus.
DATA Transmits the current reading to an
external device via the USB port. DIRECTION Toggles between clockwise and
counter-clockwise directions while
configuring set points and other menu
functions.
Note: Measurement units are configured through the menu. Refer to Section 6 for details.