Cooper Instruments & Systems Model 5i Advanced Force/Torque Indicator - Manual (Page 18)

Model 5i Digital Force / Torque Indicator User’s Guide
17
Click “Continue Anyway”.
8. The next, and final, screen appears as follows:
Click “Finish”. The Mark-10 USB device is now installed and ready to use. The COM port number
assigned by Windows may be identified in Device Manager, or in the communication application being
used, such as MESURgauge or HyperTerminal.
9.2 Serial / USB
To set up RS-232 and USB communication, select Serial/USB Settings from the menu. The screen
appears as follows:
Select either RS-232 or USB input (output is always simultaneous through both the USB and RS-232
ports). RS-232 must be selected when communicating through a Mark-10 test stand controller. When
communicating from the indicator directly to a PC or data collector, either RS-232 or USB can be selected
as required. Configure the baud rate and data format as required for the application. Default values are as
follows:
Baud Rate: 9,600
Data Format: Numeric + units
Auto Output: Disabled
Other communication settings are permanently set to the following:
Data Bits: 8
Stop Bits: 1
Parity: None
Individual data points may be transmitted by pressing DATA or by requesting the appropriate ASCII
command from an external device (see Command Set sub-section for details).
SERIAL/USB SETTINGS
* RS232 Selected
USB Selected
+ Baud Rate
+ Data Format
+ Auto Output