Yealink SIP-T19 - Manual (Page 100)

User Guide for the SIP-T19P/SIP-T19 IP Phone
90
Accept Intercom
You can enable or disable the phone to automatically answer an incoming intercom call.
If Accept Intercom is enabled, the phone automatically answers an incoming intercom
call. If Accept Intercom is disabled, the phone rejects incoming intercom calls and sends
a busy message to the caller. Accept Intercom is enabled by default.
Note
Intercom Mute
You can mute or un-mute the microphone on the phone for intercom calls automatically.
If Intercom Mute is enabled, the microphone is muted for intercom calls. If Intercom
Mute is disabled, the microphone works for intercom calls. Intercom Mute is disabled by
default.
Intercom Tone
You can enable or disable the phone to play a warning tone when receiving an
intercom call. If Intercom Tone is enabled, the phone plays a warning tone before
answering the intercom call. If Intercom Tone is disabled, the phone automatically
answers the intercom call without warning. Intercom Tone is enabled by default.
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call
while there is already an active call on the phone. If Intercom Barge is enabled, the
phone automatically answers the intercom call and places the active call on hold. If
Intercom Barge is disabled, the phone handles an incoming intercom call like a waiting
call. Intercom Barge is disabled by default.
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from
the pre-configured multicast address(es) without involving SIP signaling. You can
specify up to 10 multicast addresses that the phone listens to on the network.
How the phone handles incoming multicast paging calls depends on Paging Barge and
Paging Priority Active parameters configured via web user interface.
Your administrator can set a delay time before the phone automatically answers
intercom calls. Contact your system administrator for more information.