Call waiting – Yealink SIP-T28P User Manual
Page 109
Basic Call Features
97
group, and search for the contact (Directory should be configured in advance.
Refer to
on page
for more information.).
-
Press the Directory soft key, and then select History. Select the desired list and
use or to select the entry (Directory should be configured in advance.
Refer to
on page
for more information.).
-
Press the Directory soft key, and then select Remote Phone Book. Select the
desired group and search for the contact (Directory and remote phone book
should be configured in advance. Refer to
on page
for more information.).
3. Press the Send soft key, or to dial out.
4. After the party answers the call, press or the Transfer soft key to complete the
transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
You can cancel the transfer before the call is connected by pressing the Cancel soft key.
You can enable or disable call waiting on the phone. If call waiting is enabled, you can
receive another call when there is an active call on the phone. Otherwise, another
incoming call is automatically rejected by the phone with a busy message when there is
an active call on the phone. You can also enable or disable the phone to play a warning
tone when receiving another call.
To configure call waiting via phone user interface:
1. Press Menu->Features->Call Waiting.
2. Press or , or the Switch soft key to select Enable from the Call Waiting
field.
3. Press or , or the Switch soft key to select Enable from the Play Tone field.
4. (Optional.) Enter the call waiting on code and off code respectively in the CW On
Code and CW Off Code field.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Call waiting is configurable via web user interface at the path Features->General