Yealink VP530 - Manual (Page 82)

User Guide for the VP530 IP Video Phone
70
second party to the conference.
5. Press the Conference soft key to create a new call.
The conference is placed on hold.
6. Enter the number of the new party and then press , , or the Send soft key.
7. When the new party answers the call, press the Conference soft key to add the new
party to the conference.
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call for specific servers may be different
from introduced above. Contact your system administrator for more information.
You can use call park feature to place a call on hold, and then retrieve the call from
another phone in the system (for example, a phone in another office or conference
room). You can park an active call by tapping the call park key on the phone. If the call
is parked successfully, the response is either a voice prompt confirming that the call is
parked, or a visible indication on the LCD screen. When the call is parked successfully,
someone can retrieve the parked call on another phone.
Note
To configure a call park key via phone user interface:
1. Tap .
2. Tap the desired DSS key for one second.
3. Tap the pull-down list of Type and then select Key Event.
4. Tap the pull-down list of Key Type and then select Call Park.
5. Tap the pull-down list of Account ID and then select the desired line.
6. Enter the key label in the Label field or leave it blank.
Call Park feature is not available on all servers. Contact your system administrator for
more information.