Dell Inspiron 530 - Manual (Page 146)

146
Removing and Installing Parts
NOTE:
The location/connectors may vary depending on your system type.For more
information, see "System Board Components" on page 110.
4 Disconnect the power and data cables from the back of the floppy drive.
NOTE:
If you have installed a PCI Express x16 card, this card may cover the
floppy-drive connectors. Remove this card before disconnecting the floppy-
drive cables
(see "Removing a PCI/PCI Express Card " on page 134 )
5 Disconnect the data cable from the system board.
6 Remove the two screws securing the floppy drive.
7 Slide the floppy drive out through the front of the computer.
1 floppy drive 2 data cable 3 power cable
4 system board connector 5 screws (2)
2
4
3
1
5
book.book Page 146 Monday, October 6, 2008 11:28 AM