HP laserjet m1212nf - Manual (Page 92)

c. Select your product from the list, or click the + Add printer button to add it. To add the
product, you need the product code, which is the segment of the product e-mail address that
is before the @ symbol.
NOTE: This code is valid for only 24 hours from the time you enable HP Web Services. If it
expires, follow the instructions to enable HP Web Services again, and obtain a new code.
d. Click the Setup button. The HP ePrint Settings dialog box appears. Three tabs are
available:
● Allowed Senders. To prevent your product from printing unexpected documents, click
the Allowed Senders tab. Click Allowed Senders Only, and then add the e-mail
addresses from which you want to allow ePrint jobs.
● Print Options. To set up default settings for all ePrint jobs sent to this product, click the
Print Options tab, and then select the settings that you want to use.
● Advanced. To change the product’s e-mail address, click the Advanced tab.
Use HP Direct Print (wireless models only)
Use HP Direct Print to print directly to the product from any mobile device (such as a smart phone, net
book, or laptop computer).
NOTE: No setup is necessary, but HP Direct Print must be enabled. Your mobile device must have an
HP print application installed.
1. To enable HP Direct Print from the product control panel, follow these steps:
a. Use the arrow buttons to select the Network config. menu, and then press the OK button.
b. Use the arrow buttons to select the Wireless Menu, and then press the OK button.
c. Use the arrow buttons to select the Wireless Direct, and then press the OK button.
2. For advanced configuration options, enable HP Web Services in the HP Embedded Web Server
(EWS) by following these steps:
a. After the product is connected to the network, print a configuration page and identify the
product IP address.
b. At your computer, open a Web browser and enter the product IP address into the address
line. The HP EWS screen appears.
78 Chapter 7 Print tasks ENWW