Canon EOS 50D - Manual (Page 102)

102
By changing the shutter speed or aperture automatically, the camera
brackets the exposure up to ±2 stops in 1/3-stop increments for three
successive shots. This is called AEB.
1
Select [Expo. comp./AEB].
Under the [2] tab, select [Expo.
comp./AEB], then press <0>.
2
Set the AEB amount.
Turn the <6> dial to set the AEB
amount.
You can set the exposure compensation
amount with the <5> dial. If AEB is
combined with exposure compensation,
AEB will be applied centering on the
exposure compensation amount.
Press <0> to set the amount.
X When you exit the menu, <h> and the AEB
level will be displayed on the LCD panel.
3
Take the picture.
Focus and press the shutter button
completely. The three bracketed shots will
be taken in this sequence: Standard,
decreased, and increased exposure.
Follow steps 1 and 2 to turn off the AEB amount display.
AEB will be canceled automatically when you set the power switch
to <2> or when the flash is ready to fire.
3 Auto Exposure Bracketing (AEB)N
AEB amount
Canceling AEB
If the drive mode is set to <u>, you must press the shutter button three
times. When <o> or <i> is set and you hold down the shutter button
completely, the three bracketed shots will be taken continuously. Then
the camera will stop shooting. When <j> or <l> is set, the three
bracketed shots will be taken after a 10-sec. or 2-sec. delay.
Neither flash nor bulb exposures can be used with AEB.
COP
Y