Canon mp495 - Manual (Page 616)

E, 1, 6
(LED display)
The ink has run out. The ink has run out.
Replace the ink cartridge and close
the Scanning Unit (Cover).
If printing is in progress and you want
to continue printing, press the
machine's
Stop ( Reset ) button for at
least 5 seconds with the ink cartridge
installed. Then printing can continue
under the ink out condition.
The function for detecting the
remaining ink level will be disabled.
Replace the empty ink cartridge
immediately after the printing. The
resulting print quality is not
satisfactory, if printing is continued
under the ink out condition.
E, 2, 0
E, 2, 1
E, 2, 2
E, 2, 3
E, 2, 4
(LED display)
An error regarding network
has occurred. Refer to your setup manual or the
Network Setup Troubleshooting and
take the appropriate action.
E, 3, 0
(LED display)
The size of the original
cannot be correctly
detected or the document
is too small when the Fit-to-
Page copying is selected.
Make sure that the original meets
the requirements and is correctly
loaded on the Platen Glass.
Check the position and direction
of the original loaded on the
Platen Glass.
E, 3, 1
(LED display)
The machine is not
connected with the
computer. Connect the machine and the
computer with a USB cable or over a
wireless LAN.
E, 5, 0 Scanning the print head
alignment sheet has failed. Press the Stop/Reset button to
dismiss the error, then take the
actions described below.
Make sure that the print head
alignment sheet is set in the
correct position and orientation
on the Platen Glass.
Page 616 of 759 pages An Error Code Is Displayed on the LED