Bissell 30Z8e - Manual (Page 11)

w w w . b i s s e l l . c o m
11
M
aintenance and care
The post-motor filter is a H13 HEPA
media filter*, which assists in the fil-
tration process to return clean air to
the room.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. The post-motor filter is located behind
the door labeled “FILTER” on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3. Remove the post-motor HEPA media
filter* by grasping the handle on the
filter and pulling out to remove.
4. Replace the post-motor HEPA media
filter* with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter*.
This filter is NOT washable and must
be replaced when it becomes dirty.
5. Replace the filter door by inserting the
two tabs at the bottom of the filter door.
Then push down on the tab on the
door and push it back into the vacuum.
Release the tab on the door to lock into
place.
Cleaning the Post-motor HEPA media filter*
Post-Motor HEPA
Media Filter*
2.
3.
*The Filter Media, not the vacuum as a whole, complies with the High Efficiency
Particulate Air (HEPA) filter specification (EN 1822-1:2009).