Bissell 30Z8e - Manual (Page 12)

w w w . b i s s e l l . c o m
M
aintenance and care
12
(Select models only)
The TurboBrush Pet Tool should
be checked regularly for clogs or
debris wrapping around the brush.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible,
turn the collar on the neck of the Wide
Pet TurboBrush counterclockwise to the
unlocked position to remove the faceplate
and clear any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush.
Place the ends of the brush in the slots
on the sides. Reposition the faceplate
and turn the collar clockwise to the
locked position.
Thermal protector
An internal thremal protector has
been designed into your vacuum to
protect it from overheating. When the
thermal protector activates, the
vacuum motor will stop operating. If
this happens:
1. Turn the vacuum OFF (O) and unplug
from electrical outlet.
2. Empty dirt container, check filters and air
passages for dirt accumulation.
3. The thermal protector automatically
resets after approximately 1 hour. If the
thermal protector does not reset, call
BISSELL Consumer Services.
Maintaining the TurboBrush Pet Tool