EcoPure MW_MW25_450215A - Manual (Page 10)

...................................... AUTOMATIC WATER SOFTENER
PROGRAMMING THE ELECTRONIC DEMAND TIMER
³ TIMER SETTINGS REQUIRED...upon installation, and after an extended power outage (see Program Memory,
page 18).
NOTES:
y WHEN THE TRANSFORMER IS PLUGGED INTO THE ELECTRICAL OUTLET (STEP 11, PAGE 9), a flashing
12:00AM and PRESENT TIME show in the display area. Program the timer as instructed below. If SR - - is
flashing, use the UP + button to set the code to SR20. If you pass be the correct code number, use the DOWN –
button. Then, press the SELECT button and program the timer below. If the wrong SR code shows for your model,
see Manual Initiated Electronic Diagnostics on pages 19 and 20.
y A “beeper” sounds while pressing buttons for timer programming. One beep signals a change in the timer display.
Repeated beeps means the timer will not accept a change from the button you have pressed, and you should use
another button.
y To set the timer, you will use the UP +, DOWN – and SELECT buttons.
³ SET TIME OF DAY, AND PRESENT DAY OF WEEK
NOTE: If the words PRESENT TIME do not show in the display, press the SELECT button until they do.
1. Press the UP or DOWN button to set. The UP
button moves the display ahead; the DOWN
moves the time backward.
NOTE: Each press of the buttons changes the
time by one minute. Holding the buttons in
changes the time 32 minutes each second.
If the present time is between noon and midnight,
be sure PM shows.
If the present time is between midnight and noon,
be sure AM shows.
2. When the present time shows, press SELECT
to set.
MW-25
10