EcoPure MW_MW25_450215A - Manual (Page 20)

...................................... AUTOMATIC WATER SOFTENER
ELECTRONIC DEMAND TIMER FEATURES, AND SERVICE, continued
service: MANUAL INITIATED ELECTRONICS DIAGNOSTIC.......................................................
1 . To enter diagnostics, press and hold the SELECT
button until (000 - -) shows in the display.
(A) The first 3 digits indicate water meter operation as
follows:
° 000 (steady) = soft water not in use…no flow
through the meter.
— OPEN A NEARBY SOFT WATER FAUCET —
° 000 to 199 (continual) = repeats display for each
gallon of water passing through the meter .
If you don’t get a reading in the display, with faucet
open, pull the sensor from the valve outlet port. Pass a
small magnet back and forth in front of the sensor.
You should get a reading in the display. If you get a
reading, unhook the in and out plumbing and check
the turbine for binding.
(B) The letter (P) and dash(es) indicate POSITION
switch operation. The letter appearing means the
switch is closed; the dash means the switch is open.
Use the RECHARGE button to manually advance the
valve into each cycle and check correct switch
operation.
CORRECT
SWITCH
DISPLAYS
VALVE CYCLE STATUS
- - Valve in service, fill, brining,
backwash or fast rinse position.
- P Valve rotating from one position to
another.
(C) While in this diagnostic screen, the following
information is available and may be beneficial for
various reasons. This information is retained by the
computer from the first time electrical power is applied
to the face plate.
…Press the UP button to display
the number of days this face
plate has had electrical power
applied.
…Press the DOWN button to
display the number of
regenerations initiated by this
face plate since the model code
number was entered.
2. Press the SELECT button and
hold in 3 seconds until a model
code appears in the display.
For correct softener operation, the SR number
must be SR20.
To reset the code, press the UP or DOWN button
until the correst number shows.
3. Press SELECT to return the present time display. If
the code was changed, make ALL the timer
settings, pages 10 and 11.
NOTE: If the face plate is left in a diagnostic display (or a flashing
display when setting times or hardness), present time automatically
returns if a button is not pressed within 4 minutes.
20