CHEVROLET CORVETTE 2005 - Manual (Page 179)

RESET Button
The RESET button, used along with other buttons, will
reset system functions and turn off or acknowledge
messages on the DIC.
DIC Warnings and Messages
The following messages and warnings may appear in
the DIC display. The DIC display area is located in
the instrument panel cluster below the speedometer and
tachometer, directly above the steering column. You
may receive more than one message at a time.
Messages will appear one behind the other. To
acknowledge a message and remove it from the display,
press the RESET button. You may scroll through the
messages that may have been sent at the same
time. The message center is continuously updated
with the vehicle performance status.
ABS ACTIVE (Anti-Lock Brake System
Active): When your anti-lock system is adjusting
brake pressure to help avoid a braking skid, the
ABS ACTIVE message will be displayed.
Slippery road conditions may exist if this message is
displayed, so adjust your driving accordingly. The
message will stay on for a few seconds after the system
stops adjusting brake pressure.
ACTIVE HANDLING: Your vehicle is equipped with a
computer controlled system to assist the driver in
controlling the vehicle in difficult driving conditions. You
may feel or hear the system working and see the
ACTIVE HANDLING message displayed in the DIC.
This message will stay on for a few seconds following
the active handling event. This is normal when the
system is operating. See Active Handling System on
page 4-10 and Braking on page 4-6.
ACTIVE HANDLING CALIBRATING: This message
will display and the active handling system light on the
instrument panel cluster will be on while the system
is calibrating after exceeding 19 mph (30 km/h) for
10 seconds. See Active Handling System Light on
page 3-39. The Active Handling System is not functional
yet. The Active Handling System performance is
affected until the next message ACTIVE HANDLING
READY is displayed. The Active Handling System is off
until the ACTIVE HANDLING READY message is
displayed. See Active Handling System on page 4-10
for more information.
ACTIVE HANDLING READY: If you receive this
message, the system has completed the functional
check of the Active Handling System. See Active
Handling System on page 4-10 for more information.
3-53