FORD 2015 Expedition - Manual (Page 79)

Erasing a Personal Code
1. Enter the factory-set 5-digit code.
2. Press and release 1
•2 on the keypad within five seconds.
3. Press and hold 1
•2 for two seconds. This must be done within five
seconds of completing Step 2.
All personal codes are now erased and only the factory-set 5-digit code
will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode if you enter the wrong code
seven times (35 consecutive button presses). This mode disables the
keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity
• pressing the unlock button on the remote control
• switching the ignition on
• unlocking the vehicle using intelligent access.
Unlocking and Locking the Doors
To unlock the driver door: Enter the factory-set 5-digit code or your
personal code. You must press each number within five seconds of each
other. The interior lamps will illuminate. Note: All doors will unlock if
the two-stage unlocking feature is disabled. Refer to Locking and
Unlocking earlier in this chapter.
To unlock all doors: Enter the factory-set code or your personal code,
then press 3
•4 within five seconds.
To lock all doors: Press and hold 7
•8 and 9•0 at the same time with
the driver door closed. You do not need to enter the keypad code first.
78 Locks
2015 Expedition (exd)
Owners Guide gf, 1st Printing, July 2014
USA (fus)