Hints on driving with anti-lock brakes, Parking brake, Hill start assist – FORD 2015 Focus Electric User Manual

Page 128: Hints on driving with anti-lock, Brakes, Parking brake hill start assist

Advertising
background image

standard friction braking. When the battery
is almost fully charged, the amount of
regenerative braking is limited to avoid
overcharging, and the requested
deceleration is produced by standard
friction braking alone.

Regenerative braking does not take the
place of the standard friction brakes; it only
assists them. Regenerative braking has
also been designed to interact with the
anti-lock brake system. Regenerative
braking is disabled when the anti-lock
brake system is activated or the battery is
fully charged.

HINTS ON DRIVING WITH
ANTI-LOCK BRAKES

Note: When the system is operating, the
brake pedal will pulse and may travel
further. Maintain pressure on the brake
pedal. You may also hear a noise from the
system. This is normal.

The anti-lock braking system will not
eliminate the risks when:

You drive too closely to the vehicle in
front of you.

Your vehicle is hydroplaning.

You take corners too fast.

The road surface is poor.

PARKING BRAKE

WARNING

Always set the parking brake fully
and make sure you shift the gearshift
lever to park (P). Switch the ignition

off and remove the key whenever you leave
your vehicle.

Note: Do not press the release button while
pulling the lever up.

To apply the parking brake:

1.

Press the foot brake pedal firmly.

2. Pull the parking brake lever up to its

fullest extent.

Note: If you park your vehicle on a hill and
facing uphill, shift the gearshift lever to park
(P) and turn the steering wheel away from
the curb.

Note: If you park your vehicle on a hill and
facing downhill, shift the gearshift lever to
park (P) and turn the steering wheel toward
the curb.

To release the parking brake:

1.

Press the brake pedal firmly.

2. Pull the lever up slightly.
3. Press the release button and push the

lever down.

HILL START ASSIST

WARNINGS

The system does not replace the
parking brake. When you leave your
vehicle, always apply the parking

brake and shift the transmission into park
(P) for automatic transmission or first gear
for manual transmission.

You must remain in your vehicle once
you have activated the system.

During all times, you are responsible
for controlling your vehicle,
supervising the system and

intervening, if required.

If the engine is revved excessively, or
if a malfunction is detected, the
system will be deactivated.

The system makes it easier to pull away
when your vehicle is on a slope without the
need to use the parking brake.

125

Focus (CDH), enUSA, First Printing

Brakes

Advertising