FORD 2014 Focus Electric - Manual (Page 327)

Start and Finish display the times, which you can modify, using the
following:
• + and - allow you to change the hours and minutes of your start and
finish times.
• AM and PM allow you to change the time of your start and finish
time. This setting is viewable in 12-hour mode.
240V and 120V represent the voltage service the default profile is using.
The system uses this selection to calculate estimated charge times.
Clear erases the Default Value Charge preferences.
Save All stores your Default Value Charge preferences.
• Note: Make sure you save your settings before returning to the
previous screen. If you do not touch Save, your settings are not
stored in the system.
Power
This screen displays how the electric vehicle system transfers power in
order to accelerate or recharge the battery. The power flow screens show
power going to or through a component. These screens are for your
information only, and do not require any input from you.
Depending on your vehicle type, the power flow screen may vary in
order to show the appropriate components.
Note: Vehicle configuration and status displayed may not always match
actual vehicle state due to display constraints and simplified graphics.
A. Motor-to-wheel flow shows the direction of power flow between the
wheels and the electric motor.
A
D
G
E F
B
C
H
326 MyFord Touch®
2014 Focus Electric Vehicle (fob)
Owners Guide gf, 1st Printing, May 2013
USA (fus)