FORD 2013 Expedition v.1 - Manual (Page 105)

To reset the oil monitoring system to 100% after each oil change,
perform the following:
1. Press and release the SETUP button to display “OIL LIFE XXX%
HOLD RESET = NEW”.
2. Press and hold the RESET button for two seconds and release to reset
the oil life to 100%.
Note: To change oil life 100% value (if equipped with this feature) to
another value, proceed to Step 3.
3. Once “OIL LIFE SET TO XXX%” is displayed, release and press the
RESET button to change the Oil Life Start Value. Each release and press
will reduce the value by 10%.
• UNITS ENG / METRIC: Displays the current units in English or Metric.
• AUTOLAMP: This feature keeps your headlights on for up to three
minutes after the ignition is switched off.
• AUTOLOCK: This feature automatically locks all vehicle doors when
the vehicle is shifted into any gear, putting the vehicle in motion.
• AUTOUNLOCK: This feature automatically unlocks all vehicle doors
when the driver’s door is opened within 10 minutes of the ignition
being turned off.
• TRAILER SWAY (if equipped): This feature uses the electronic
stability control to mitigate trailer sway.
• TBC MODE (if equipped): Allows you to choose the trailer brake
mode.
• CREATE MYKEY / MYKEY SETUP / CLEAR MYKEY: For more
information refer to the MyKey
௡ chapter.
• LANGUAGE = ENGLISH / SPANISH / FRENCH: Allows you to choose
which language the message center will display in.
Waiting four seconds or pressing the SELECT/RESET stem cycles the
message center through each of the language choices.
Press the SELECT/RESET stem to set the language choice when the
language you want appears.
Information Displays 105
2013 Expedition (exd)
Owners Guide gf, 1st Printing
USA (fus)