374 wheels and tires – FORD 2013 F-150 v.1 User Manual

Page 374

Advertising
background image

3. Cycle the ignition to the on position with the engine off.

4. Turn the hazard flashers on then off three times. This must be
accomplished within 10 seconds.

If the reset mode has been entered successfully, the horn will sound
once, the TPMS indicator will flash and a message is shown in the
information display (if equipped). If this does not occur, please try again
starting at Step 2.

If after repeated attempts to enter the reset mode, the horn does not
sound, the TPMS indicator does not flash and no message is shown in
the information display (if equipped), seek service from your authorized
dealer.

5. Note: Train the TPMS sensors in the tires using the following TPMS
reset sequence starting with the left front tire in the following clockwise
order:
• Left front (Driver’s side front tire)
• Right front (Passenger’s side front tire)
• Right rear (Passenger’s side rear tire)
• Left rear (Driver’s side rear tire)
6. Remove the valve cap from the valve stem on the left front tire;
decrease the air pressure until the horn sounds.

Note: The single horn chirp confirms that the sensor identification code
has been learned by the module for this position. If a double horn is
heard, the reset procedure was unsuccessful, and must be repeated.

7. Remove the valve cap from the valve stem on the right front tire;
decrease the air pressure until the horn sounds.

8. Remove the valve cap from the valve stem on the right rear tire;
decrease the air pressure until the horn sounds.

9. Remove the valve cap from the valve stem on the left rear tire;
decrease the air pressure until the horn sounds.

Training is complete after the horn sounds for the last tire trained
(driver’s side rear tire), the TPMS indicator stops flashing, and a
message is shown in the information display (if equipped)..

10. Turn the ignition off. If two short horn beeps are heard, the reset
procedure was unsuccessful and must be repeated.

If after repeating the procedure and two short beeps are heard when the
ignition is turned to off, seek assistance from your authorized dealer.

11. Set all four tires to the recommended air pressure as indicated on
the Safety Compliance Certification Label (affixed to either the door

374

Wheels and Tires

2013 F-150 (f12)
Owners Guide gf, 1st Printing
USA
(fus)

Advertising