Autounlock (if equipped), Deactivating/activating autolock/autounlock, Locks and security – FORD 2012 Fiesta v.1 User Manual

Page 134

Advertising
background image

Autounlock (if equipped)

If the doors have been autolocked, the doors will autounlock only when:
• the ignition is on,

• all doors are closed,

• the vehicle has been in motion at a speed greater than 12 mph

(20 km/h) for more than 2 seconds,

• the vehicle comes to a stop,

• the ignition is turned off or to accessory,

• the driver door is opened within 10 minutes of the ignition being

switched from on to off or accessory.

Note: If you use the power door lock button to lock the doors before an
autolock event, the doors will not autounlock.

Deactivating/activating autolock/autounlock

Note: When programming the autolock feature, carry out the following
steps within 30 seconds or the procedure needs to be repeated. If the
procedure needs to be repeated, wait 30 seconds between programming
sessions.
1. Turn the ignition on.
2. Press the power door lock control three times.
3. Turn the ignition off.
4. Press the power door lock control three times.
5. Turn the ignition on. The module is now in programming mode.

Note: A chime sounds as acknowledgement that the programming mode
has been entered. The safety belt must be engaged otherwise the
Belt-Minder

௡ chime will take priority over other chimes.

6. Once in programming mode, the autolock or autounlock feature can be
programmed independently of each other.

• To program the autolock feature, press the power door lock control

for greater than 2 seconds and release. Each long press of the
power door lock control toggles the state of the autolocking feature
between enabled and disabled. A chime sounds when the feature is
enabled or disabled.

• To program the autounlock feature, press the power door lock control

for less than 1 second and release. Each short press of the power
door lock control toggles the state of the autounlocking feature
between enabled and disabled. A chime sounds when the feature is
enabled or disabled.

7. Turn the ignition off to exit programming. If a setting was toggled, a
chime will be heard.

Locks and Security

134

2012 Fiesta (fie)
Owners Guide, 1st Printing
USA
(fus)

Advertising