Locks and security – FORD 2011 Explorer v.3 User Manual

Page 130

Advertising
background image

• If equipped, any of the following: parking aid, blind spot information

system (BLIS

௡) with cross traffic alert and forward collision warning

systems cannot be turned off.

Optional settings – these settings can be changed
• Vehicle speed is limited to 80 mph (130 km/h). Visual warnings are

displayed followed by a chime when the vehicle speed has reached
80 mph (130 km/h).

• Visual warnings are displayed followed by a chime when a preselected

vehicle speed of 45, 55 or 65 mph (75, 90, or 105 km/h) is exceeded.

• The maximum volume of the audio system is limited to 45%. MYKEY

VOLUME LIMITED will be displayed in the audio system display when
attempting to exceed the limited volume.

• The AdvanceTrac௡ system cannot be turned off. When this optional

setting is on, the MyKey

௡ user will not be able to deactivate the

system. Note: It may be beneficial to deactivate the AdvanceTrac

system if the vehicle is stuck in snow, mud, or sand.

Create a MyKey

To program MyKey

௡ on one of the keys programmed to the vehicle,

insert the key that you want to make a MyKey

௡ into the ignition. For

vehicles equipped with push button start, put the intelligent access key
in the backup slot with brand logo facing up; refer to Starting in the
Driving chapter for the location of the backup slot. Turn the ignition on.
Use the message center buttons to do the following:

1. Get into main menu, select SETTINGS then MYKEY by pressing OK
button or the right arrow button.

2. Press OK to select CREATE MYKEY.

3. Hold the OK button as prompted until you see a message that the key
is restricted.

MyKey

௡ is successfully programmed. Make sure you label it so you can

distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey

Optional Settings

section. If your vehicle is equipped with remote start, see the Using
MyKey

with remote start systems section.

Note: All MyKeys

௡ can be cleared within the same key cycle that it was

created, otherwise an admin key is required to clear the MyKey

programming. To clear all MyKeys

௡ go to Step 2 in the Clear MyKey

section.

Locks and Security

130

2011 Explorer (exp)
Owners Guide, 4th Printing
USA
(fus)

Advertising
This manual is related to the following products: