Car finder, Sounding a panic alarm, Opening the power liftgate (if equipped) – FORD 2011 Explorer v.3 User Manual

Page 142: Locks and security

Advertising
background image

Car finder

Press

twice within three seconds. The horn will chirp and the turn

lamps will flash. It is recommended that this method be used to locate
your vehicle, rather than using the panic alarm.

Sounding a panic alarm

Press

to activate the alarm. Press again or turn the ignition to on to

deactivate.

Note: The panic alarm will only operate when the ignition is off.

Opening the power liftgate (if equipped)

Press

twice within three seconds to fully unlatch and open the

liftgate.

WARNING: Make sure all persons are clear of the liftgate area
before using power liftgate control.

In order to fully lower and latch the liftgate, press the control twice.

If the liftgate stops mid-travel, it may have detected an obstacle. Check
to ensure the liftgate swing zone is free from obstruction and reset the
power assist by manually closing the liftgate. Normal operation can then
be resumed. Liftgate open/close can be reversed by pressing

twice

within three seconds.

WARNING: Make sure the liftgate is closed to prevent exhaust
fumes from being drawn into the vehicle. This will also prevent

passengers and cargo from falling out. If you must drive with the
liftgate open, keep the vents open so outside air comes into the
vehicle.

Locks and Security

142

2011 Explorer (exp)
Owners Guide, 4th Printing
USA
(fus)

Advertising
This manual is related to the following products: