Speed sensitive steering, Driving – FORD 2011 Fusion v.1 User Manual

Page 217

Advertising
background image

3.5L V6 Duratec

engine: Your vehicle is equipped with a hydraulic

steering system.

To help prevent damage to the power steering system, never hold the
steering wheel at its furthest turning points (until it stops) for more than
a few seconds when the engine is running. If the power steering system
breaks down (or if the engine is turned off), you can steer the vehicle
manually, but it takes more effort.
• Do not operate the vehicle with a low power steering pump fluid level

(below the MIN mark on the reservoir).

• Some noise is normal during operation. If excessive, check for low

power steering pump fluid level before seeking service by your
authorized dealer.

• Heavy or uneven steering efforts may be caused by low power steering

pump fluid level. Check for low power steering pump fluid level before
seeking service by your authorized dealer.

• Do not fill the power steering pump reservoir above the MAX mark on

the reservoir, as this may result in leaks from the reservoir.

All engines

If the steering wanders or pulls equipped with either an EPS or a
hydraulic steering system, check for:
• an improperly inflated tire
• uneven tire wear
• loose or worn suspension components
• loose or worn steering components
• improper steering alignment
A high crown in the road or high crosswinds may also make the steering
seem to wander/pull.

Speed sensitive steering

The steering in your vehicle is speed sensitive. At lower speeds the assist
is increased to improve maneuverability.

If the amount of effort required to steer your vehicle changes while
driving at a constant vehicle speed, have the power steering system
checked by your authorized dealer.

Driving

217

2011 Fusion (fsn)
Owners Guide, 1st Printing
USA
(fus)

Advertising