Two-step door unlocking, One-step door unlocking, Switching from two step to one step door unlocking – FORD 2010 Transit Connect v.3 User Manual

Page 64: Unlocking cargo doors, Locking the doors, Replacing the battery, Locks and security

Advertising
background image

Two-step door unlocking

• Press

and release to unlock the front and sliding doors.

• Within three seconds, press

and release again to unlock all the

doors.

Note: The interior lamps will illuminate if the control on the overhead
lamp is not set to the off position.

One-step door unlocking

If the one step door unlocking feature is activated, press

and release

once to unlock all the doors. Note: The interior lamps will illuminate
(refer to the Illuminated entry feature later in this section), if the
control on the overhead lamp is not set to the off position.

Switching from two step to one step door unlocking

Your vehicle comes with two step unlocking enabled. With the vehicle
locked, unlocking can be switched between two step and one step door
unlocking by pressing and holding both the

and

buttons

simultaneously on the remote entry transmitter for approximately four
seconds and release. The turn signal lamps will flash twice to indicate
that the vehicle has switched to one step unlocking. Repeat the
procedure to switch back to two-step unlocking.

Unlocking cargo doors
• Press

to unlock the cargo doors.

• Within three seconds, press

again to unlock all the vehicle

doors.

Ensure that the cargo doors are closed and latched before driving your
vehicle. Failure to properly latch the cargo doors may cause objects to
fall out.

Locking the doors

• Press

and release to lock all the doors. If all doors are closed the

turn signal lamps will flash twice.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.

Locks and Security

64

2010 Transit Connect (tst)
Owners Guide, 3rd Printing
USA
(fus)

Advertising