FORD 2007 Crown Victoria v.2 - Manual (Page 58)

Operating the HomeLink ா Wireless Control System
To operate, simply press and release the appropriate HomeLink
௡ button.
Activation will now occur for the trained product (garage door, gate
operator, security system, entry door lock, or home or office lighting
etc.). For convenience, the hand-held transmitter of the device may also
be used at any time. In the event that there are still programming
difficulties, contact HomeLink
௡ at www.homelink.com or
1–800–355–3515.
Erasing HomeLink ா buttons
To erase the three programmed buttons (individual buttons cannot be
erased):
• Press and hold the two outside
buttons. The message CLEARING
CHANNELS will appear on the
HomeLink
௡ display.
• After about 20 seconds, the
message CHANNELS CLEARED
will appear on the display. Do not
hold for longer that 30 seconds.
HomeLink
௡ is now in the train
(or learning) mode and can be
programmed at any time
beginning with step 2 in the
“Programming” section.
Reprogramming a single HomeLink
ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
2007 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
58