Locks and security – FORD 2005 Escape v.2 User Manual

Page 81

Advertising
background image

If any of the doors or the hood are not properly closed, the horn will
chirp twice and park lamps will not flash when the

control is pressed.

Sounding a panic alarm

Press

to activate the alarm. To deactivate the feature, press the

control again or wait for the alarm to time out in approximately 3
minutes.

Note: The panic alarm will only operate when the ignition is in the 1
(LOCK) or 2 (ACCESSORY) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two
halves of the remote entry
transmitter near the key ring. DO
NOT TAKE THE RUBBER COVER
AND CIRCUIT BOARD OFF THE
FRONT HOUSING OF THE
REMOTE ENTRY TRANSMITTER.

2. Do not wipe off any grease on the
battery terminals on the back
surface of the circuit board.

3. Remove the old battery.

4. Insert the new battery. Refer to the diagram inside the remote entry
transmitter for the correct orientation of the battery. Press the battery
down to ensure that the battery is fully seated in the battery housing
cavity.

5. Snap the two halves back together.

2005 Escape (204)
Owners Guide (post-2002-fmt)
USA English
(fus)

Locks and Security

81

Advertising