Locks and security – FORD 2004 F-150 v.5 User Manual

Page 92

Advertising
background image

system has been disabled. Conversely, two horn chirps followed by a
honk will indicate that the system is enabled.

4. Pressing the power door

control two times again will turn the

feature ON if it was previously OFF, or OFF if it was previously ON.
Every two consecutive presses of the

control after successfully

entering the configuration mode will change the enable/disable condition
of the feature.

5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.
Note: After exiting the driver configuration mode, the horn will chirp
once to indicate a feature has been activated/deactivated.

Autolock (if equipped)

The autolock feature will lock all the doors when:
• all the doors are closed,
• the ignition is in the 3 (ON) position,
• you shift into any gear putting the vehicle in motion, and
• the brake pedal is released and the vehicle attains a speed greater

than 5 mph (8 km/h).

The autolock feature repeats when:
• any door is opened then closed while the ignition is in the 3 (ON)

position, and

• the brake pedal is released and the vehicle attains a speed greater

than 5 mph (8 km/h).

Deactivating/activating autolock

Your vehicle comes with the autolock feature activated. There are three
methods to enable/disable this feature: One is through your dealer, the
second with a power door unlock/lock sequence and the third with the
keypad.

Before following the activation or deactivation procedures, make sure the
ignition is off, and all vehicle doors are closed.

2004 F150 (f12)
Owners Guide (post-2002-fmt)
USA English
(fus)

Locks and Security

92

Advertising