Craftsman LAWNSWEEPER 486.242211 - Manual (Page 6)

6
FIGURE 4
STEP 4: (SEE FIGURE 4)
• Cut off the plastic tie that holds the height adjustment
tube in place.
• Assemble the R.H. hitch tube to the sweeper housing
using two 5/16" x 1-1/2" carriage bolts (C), and two
5/16" nylock nuts (J).
Do not tighten yet. Repeat for
the L.H. hitch tube.
FIGURE 3
STEP 3: (SEE FIGURE 3)
• Attach the brush assembly with the black brush
retainer to the left end of the brush shaft using two
1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with black ink must be placed
to the
middle of the sweeper.
• Turn a wheel to rotate the brushes. (The wheels drive
the brushes in one direction only.) The overlap bristles
should be on the back side of the brush as it rotates.
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED BLACK 5/16" x 1-1/2"
CARRIAGE BOLT (C)
5/16" NYLOCK NUT (J)
STEP 5: (SEE FIGURE 5)
• Fasten the hitch tubes together using two 5/16" x
2-1/2" hex bolts (A) and 5/16" nylock nuts (J). Do not
tighten yet.
5/16" x 2-1/2"
HEX BOLT (A)
5/16"
NYLOCK NUT (J)
FIGURE 5