Craftsman LAWNSWEEPER 486.242211 - Manual (Page 8)

8
ASSEMBLY OF HOPPER BAG
STEP 10: (SEE FIGURE 11 AND 12)
• Turn a rear hopper tube so that the brace holes in the
middle of the tube face down. Slide the tube through
the two loops sewn to the top rear seam inside the
hopper bag.
STEP 9: (SEE FIGURE 10)
•
Place the star washer (L) between the height
adjustment handle and the height adjustment strap.
Insert the 5/16" x 1" carriage bolt (F) through the
height adjustment handle, the star washer and the
height adjustment strap. Assemble a 5/16" flat washer
(K) and the plastic knob (X) onto the end of the bolt.
5/16" FLAT
WASHER (K)
5/16" x 1"
CARRIAGE BOLT (F)
PLASTIC KNOB (X)
STAR WASHER (L)
(between strap and handle)
REAR HOPPER TUBE
(brace holes on bottom)
INNER BAG LOOPS
• Insert the two upper hopper side tubes through the
stitched flaps on each side of the hopper bag.
• Assemble the ends of the rear hopper tube onto the
ends of the upper hopper side tubes. Fasten together
using plastic plugs (Z).
UPPER HOPPER
SIDE TUBE
PLASTIC PLUG (Z)
FIGURE 10
FIGURE 11
FIGURE 12