Country Home Products DR ALL-TERRAIN FIELD and BRUSH MOWER - Manual (Page 18)

14 DR
®
GENERATOR ATTACHMENT
1. Refer to Figure 15 for the proper relay
color code connections in the event your
relay should become disconnected.
2. Run the lower end of the new Interface
Relay Harness, with the Relay attached,
down along the handlebar and in back of
the Right Tank Support (Figure 16).
3. Mount the Interface Relay vertically
against the inside of the Tank Support
(Figure 14) using the Screw and Locking
Nut supplied.
4. Plug the Connector D (Figure 11), from
the Relay, into the Generator Harness
(Figure 17).
5. Secure the new wire harness to the
existing ATM harness as shown using a
Cable Tie provided (Figure 17).
6. Secure the upper portion of the Wire
Harness to the handlebar frame using the
plastic Cable Ties provided (Figure 18).
Your installation is now complete.
Figure 15
Figure 17 Figure 18
ATM Harness
Cable Tie
Generator
Harness
Figure 16
Connector D
from Relay
Right Tank Support
Interface Relay
behind Support
Interface Relay Harness
Cable Tie
Cable Tie
Right Tank
Support