Country Home Products DR ALL-TERRAIN FIELD and BRUSH MOWER - Manual (Page 19)

CALL TOLL FREE 1-800-DR-OWNER 15
Installing the Maintenance Meter (if you don’t have one)
Tools & Parts Needed:
• Screwdriver
• Cutting Pliers
• Meter Assembly #184271 Includes:
• Meter
• 66" Wire
• Control Panel Plug w/cutout
• Mounting Bracket
• Cable Ties
NOTE: Do not place the Mounting Bracket on the Meter before the Meter is inserted into the Control Panel.
1. Gently pry the black factory Panel Insert from the
Control Panel (Figure 19).
2. Insert the Control Panel Plug from the new Meter Kit
into the open hole in the Control Panel (Figure 20).
3. Insert the Meter firmly into the Panel Plug. The Meter
Flange should be flat against the face of the Panel
Plug.
4. Thread the Sensor Wire Adapter through the Meter
Mounting Bracket as shown (Figure 21) leaving
sufficient wire length to form a loop when the
connector is placed on the Meter.
5. Place the Mounting Bracket with Sensor wire
attached, on the Meter from the backside of the Panel.
Press the Mounting Bracket as far as possible toward
the Control Panel while holding the Meter in place
from the front. The Bracket should click into place.
6. Slide the Connector onto the male fitting on the back
of the Meter. When finished, the assembly should
appear as in Figure 22.
Figure 19
Figure 20
Figure 21 Figure 22
Front Panel
Insert
Sensor Wire
Adapter
Control Panel
Control
Panel
Plug
Mounting
Bracket
Sensor
Wire
Adapter
To Meter
To Engine
Spark Plug
Connector
Flange
Meter