Hudson Robotics Bar Code Print and Apply - Manual (Page 6)

Print and Apply User Manual Hudson Robotics, Inc.
4
2. Open the Hudson box and remove the applicator from the box, also
remove any additional components from this box. Place the applicator on
the table next to the alignment base.
3. You will now attach the applicator base to the alignment base. To do so,
you will open the latches on the alignment base (See Figure 3). Then you
will slide the alignment base into the cutout in the applicator base. You
will now move the latches down until they meet the catches. Slowly turn
the latch handles until they close and push the handle down to lock the
latch into location (See Figure 4). Slowly move the alignment base to
make sure that the bases are securely attached.
Figure 3 Figure 4
4. Open the Zebra box and remove the Printer from the box. You will have
to remove the shipping straps from around the printer, before removing the
printer from the box. You will slowly lift the printer out of the box and
install it on the alignment base. You will place the printer on top of the
alignment base and match up the two countersunk holes with the two ball
end leveling feet. The ball end leveling feet will keep the printer secured
onto the alignment base (See Figure 5)