Ram Trucks uconnect 8.4AN for Chrysler - Manual (Page 192)

radio; use the device controls instead. Adjust the volume
with the VOLUME & MUTE rotary knob, or with the
volume of the attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too low,
there will be insufficient audio signal for the radio unit to
play the music on the device.
Source
Touch the Source soft-key to select the desired audio
source: AUX. This screen will time out after a few
seconds and return to the main radio screen if no
selection is made.
Audio
Refer to Radio Mode for adjusting the audio settings.
SD Card Mode — If Equipped
Overview
SD Card Mode is entered by either inserting a SD Card
into the SD Card slot or touch the SD Card soft-key on the
left side of the display. Once in Media Mode, touch the
source soft-key and select SD Card.
Seek Up/Down
Touch and release the right arrow soft-key for the next
selection on the SD Card. Touch and release the left arrow
soft-key to return to the beginning of the current selec-
tion, or to return to the beginning of the previous
selection if the SD Card is within the first second of the
current selection.
3
Uconnect® 8.4A 191