Ram Trucks uconnect 8.4AN for Chrysler - Manual (Page 91)

• Upon accessing the Timers screen after an ignition
cycle and/or battery disconnect, the driver will see the
“Best” set of values for all performance indicators, as
received from the cluster.
• If accessing Timers screen after an ignition cycle
and/or battery removal, if the driver selects “Current”,
double dashes (“- -”) will display for all timers, until
real values can be acquired.
• The “Current” ticket maintains the same values until
the vehicle speed is greater than 0 again, assuming the
driver is beginning another run. This functionality is
based upon the data as it is received from the cluster.
• Once the vehicle speed is greater than 0 again, the
“Current” page values are moved to the “Last” page
and the “Current” page is cleared out. The “Last”
ticket shows only the exact last run, not the last value
for each timer.
FAQs
1. How do I get SRT Performance Pages? This App is
pre-loaded from the factory.
2. Do I turn Performance Pages “ON” or “OFF” at any
time? No. You do not need to do anything to start or
stop performance pages or Timers. The vehicle is
always running and calculating this information.
3. Why are these specific measurements shown in
Timers? Measurements were shown that were com-
mon measures to performance driving.
4. Do I need to register? You need to register the vehicle
and subscribe to Uconnect® Access in order to get SRT
Performance Pages Plus. If a customer does not regis-
ter, SRT Performance Pages will still be available.
90 ALL ABOUT Uconnect® ACCESS