Cobra Electronics MICROTALK CXR925C - Manual (Page 14)

Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Mode Functions
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that memory
location.
b. Your radio will remain on that memory location and return to
Standby mode. Press the Channel Up or Channel Down button to
resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
a transmission.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on the channel/
privacy code that was displayed before you entered mode
functions or memory location on which, during scanning, you last
received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode
on the channel/privacy code that was displayed before you entered
mode functions or the memory location on which, during scanning,
you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 17
to de-program a memory location.)
Operation
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Customer Assistance Warranty Introduction Operation
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Memory Location Scan
•
Your microTALK ® radio can automatically scan up to
10 programmed Memory Locations.
If there are one or fewer memory locations
programmed in your radio, the scan memory
locations option will not be available. To program
at least two (2) memory locations, see program
memory locations on page 14.
To scan memory locations:
1. Press the Mode button until the Scan icon,
Memory icon and the memory location number
flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning memory locations.
The Scan icon and the Memory icon will continue
to be displayed when memory
location scan is on. Your radio will continue
to scan memory locations and stop if an incoming
transmission is detected. Your
radio will remain on that memory location
for 10 seconds.
While setting memory location scan, if you
do not press any buttons for 15 seconds,
your radio will automatically return to
Standby mode on the channel/privacy code
displayed before you entered mode functions.
Scanning Locations
Mode Button
LI 7300
Channel Button
22 English 23 Nothing Comes Close to a Cobra ®
CXR925C_ENG_MANL.indd 22-23 12/15/09 2:19 PM