Baumer BA DenexGripperLED - Manual (Page 13)

User Manual DENEX Gripper LED 13/24 Baumer Electric AG
Version 2013-02, V1.4 www.baumer.com Frauenfeld, Switzerland
6.4 DIP-Switch Settings
An 8-pole DIP-switch can be reached via the lid on top of the sensor. Unscrewing the
screw opens the lid.
The software can be controlled via the DIP switches.
DIP-Switch positions
= OFF
= ON
DIP-switches 1-4 are reserved for factory.
DIP-switches 5-8 are for selecting operation mode
All in OFF-position is the default setting.
DIP-Switches
5 6 7 8
Mode 0 =
Default Standard newspaper: 15% Blocking, Output 5ms
Mode 1 Double production: 30% Blocking time. Output 5 ms
Mode 2 Gripper Pulse Mode Output NO, Reset on falling edge of speed sensor
Mode 3 Gripper Pulse Mode Output NC, Reset on falling edge of speed sensor
Mode 4 Gripper Pulse Mode Output NO, Reset on rising edge of speed sensor
Mode 5 Gripper Pulse Mode Output NC, Reset on rising edge of speed sensor
Mode 6 Gripper Pulse Mode Output NO, Reset on falling edge of speed sensor
Mode 7 Standard newspaper: 15% Blocking, Output 20ms
Mode 8 Double production: 30% Blocking time, Output 20 ms
Mode 9 Standard newspaper: 30% Blocking, Output 20ms
Mode 10 reserved
Mode 11 reserved
Mode STATUS LED shows:
0 Lit when target is recognized by sensor
1 Lit when target is recognized by sensor
2 Speed sensor status
3 Speed sensor status
4 Speed sensor status
5 Speed sensor status
6 Lit when target is recognized by sensor
7 Lit when target is recognized by sensor
8 Lit when target is recognized by sensor
9 Not applicable